CCNA - Inter-VLAN routing LAB

 LAB: Inter VLAN routing   

Objective: To configure Inter-Vlan routing between two VLANS

Topology:

 

Router f0/0
Router f0/0.1 (sub-interface 1)	192.168.1.1
Router f0/0.2  (sub-interface 2)	192.168.2.1
PC -1	192.168.1.2
PC- 2	192.168.1.3
PC-3	192.168.2.2
PC -4	192.168.2.3
Switch 1 – F0/24	Enable trunk

Switch-1#configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Switch-1(config)#vlan 10

Switch-1(config-vlan)#name sales

Switch-1(config-vlan)#exit

Switch-1(config)#vlan 20

Switch-1(config-vlan)#name hr

Switch-1(config-vlan)#exit

Switch-1(config)#interface range fastEthernet 0/1-2

Switch-1(config-if-range)#switchport mode access

Switch-1(config-if-range)#switchport access vlan 10

Switch-1(config-if-range)#exit

Switch-1(config)#interface range fastEthernet 0/3-4

Switch-1(config-if-range)#switchport mode access

Switch-1(config-if-range)#switchport access vlan 20

Switch-1(config-if-range)#exit

Switch-1(config)#exit

Switch-1#

%SYS-5-CONFIG_I: Configured from console by console

Switch-1(config)#interface fastEthernet 0/24

Switch-1(config-if)#switchport mode trunk

Switch-1(config-if)#switchport trunk allowed vlan all

Switch-1(config-if)#exit

Switch-1(config)#exit

Switch-1#

Router Configuration:

Router-1(config)#interface fastEthernet 0/0

Router-1(config-if)#no shutdown

Router-1(config-if)#exit

Router-1(config)#interface fastEthernet 0/0.1

Router-1(config-subif)#encapsulation dot1Q 10

Router-1(config-subif)#ip address 192.168.1.1 255.255.255.0

Router-1(config-subif)#exit

Router-1(config)#interface fastEthernet 0/0.2

Router-1(config-subif)#encapsulation dot1Q 20

Router-1(config-subif)#ip address 192.168.2.1 255.255.255.0

Router-1(config-subif)#exit

Router-1(config)#

Verification